Zip Drive Installation
Just like any other IDE device, a zip drive connects to an IDE cable and a power cable. The rear side of the ZIP drive looks similar to the image below.
On the left hand side you have the IDE connector. On the right hand side you have the power connector. In the middle you have the jumpers. You have to specify if the ZIP drive is being connected as a Master or a Slave device using the appropriate jumper setting.
Place the ZIP drive into a mounting slot and screw it securely into position.
Connect the power cable and the IDE cable to the corresponding connectors. Connect the other end of the IDE cable to the IDE socket on the motherboard. Make sure the pin 1 on the cable connects to pin 1 on the motherboard IDE socket and on the ZIP drive socket.
